We are using DJI Terra to do 2D multispectral reconstructions. The laptop we are using was purchased for field use but has the miniumum specs required (4GB NVIDIA card, 16GB RAM) but out of 6 captures we recently did (each of approximately 5ha) half of them crash and the other produce patchy results. It almost looks like the software has stitched together different bands from adjacent images. Any ideas? Could this just be the minimum specs are not good enough?

G'day Hydro ... stitching problems are usually due to the subject matter not offering enough identifiable common points for the stitching software to work with.

If you put the images on dropbox or similar and post a link, I can run them through Agisoft and get an idea of whether the issue might be due to the actual images or the processing.

Hello, HydroMultiSpec. For your issues. I will divide them into two parts and answer your questions separately.
First, about the patchy stitching, those stitching are the traces left from piecing together
pictures, which cannot be erased by algorithm as yet. The same issue appears in other software too. We will forward it to designated team and improve the algorithm later to solve this issue.
Next, about the picture crashes, could you please take actions as the instructions to see whether it works? The instructions will be sent through PM in the form of DOC.
At last, if those still cannot figure out your issues, please sent us the log through the link.
Notes:
Only send us the logs on which date the issues occurred.