on the naza lite should i steer away from simon k controllers. i am having problems getting all motors to start together/also are bec type ,but did remove power from these.30 amp on 920 kv motors.

No, I run them on some of my craft. You do need to increase motor idle setting though.

Blade_Strike Posted at 2014-11-27 00:39
No, I run them on some of my craft. You do need to increase motor idle setting though.

i went from lowest setting to high setting but same results, nothing in between though .any help or advise you give is training for me .thanks,   


will get back at it after holiday .

Try the 3/4 setting.

@barryshumake  Try to calibrate the ESC

Most of the time Simonk esc don't need calibration but wouldn't hurt.. Thanks Autumn.

Blade_Strike Posted at 2014-11-27 22:31
Most of the time Simonk esc don't need calibration but wouldn't hurt.. Thanks Autumn.

Mine did or I should I did it anyways and I set the idle to high before they would work.

Yeah, I always had to change motor idle speed to high for them to arm properly.