PowerBand1
lvl.4
Australia
Offline
|
Tinus08 Posted at 8-29 00:19
Goodmorning all, and thanks for the suggestions so far.
The calibration I already found in the faq, and did that, however I did not had much hope in that, because that would not stop the motor overload- pop-up. And indeed, it did not help a thing. I can relate if 1 motor is bad, it won’t keep up with the other 3, and overload. If the others decelerate, problem solved. Also with 1 motor less good, it has problems to hover right. It is not a small wobble, it will raise and fall several meters every now and then. But sometimes it goes ok. Very hard to land. So it would be very helpful if someone could tell me if there is a way to find out which motor could be bad.
Maybe on way to find out is to fly the drone for a short while and land and feel all the motors, if one is warmer than all others...bingo |
|