Has anyone tried the alloy mounting plates for the quick release props from the seller below?

http://www.ebay.com/itm/15173283 ... =STRK%3AMEBIDX%3AIT

Chris,
I sent a PM

PM didn't come through

I would like to know this as well since the plsstic ones seems a bit risky.

CameraLensRenta Posted at 2015-7-31 02:41
Chris,
I sent a PM

PM didn't come trough

I have purchased the Alloy Hub set from this Seller, They are working perfect, I think they run a tighter tolerance  because of the nice tight fit. Also I think there is less vibration as well.

http://www.inspirepilots.com/thr ... e-prop-mounts.4251/

a thread on inspirepilots forum.
it seems to be a divided topic, with people on both sides of the argument
I have a set, in my case
I'm still happily flying self tightening w prop locks, but picked these up in case I wanted to switch to my set of QR

I have also purchased the Alloy Hub set from this Seller, I have over 20 flights now and no problems.

I have also purchased both the Alloy Hub set and the Alloy Mounting plate. I have done extensive fight time with time spent examining the propellers for any damage around the hub area. Both the mounting plate and the alloy hubs have been faultless with less vibration and noise after being installed.