The SRT file generated from a flight appears to reporting my altitude relative to either the takeoff position or the controller.
Is there a method to adjust this pre flight so that the altitude reported in the SRT file is from Sea Level?
If not can anyone think of an easier way to adjust the SRT to add to the altitude value to more accurately represent the value for import?
As an example lets say I knew I was launching from 400 Meters about see level.
When I start recording from launch it would indicate my altitude of
[altitude: 0.00000]
at max altitude
[altitude: 121.92000]
Can anyone think of a streamlined way to modify the entire SRT file to adjust the altitude up 400 meters?
Hi!
You might be better off posting your question in the 'products' section of this forum.
That is way more active.
Just create a new thread here : https://forum.dji.com/forum-129-1.html and select the right category / subcategory.