keir
lvl.1
Australia
Offline
|
I posted this to another forum section. it was suggested I post here
i have a Mavic Enterprise 2 dual thermal. The aircraft is awesome but there are some software problems.
I wish to set a frame rate of 48 frames a second (Standard for television in Australia) and set the codec.
I was unabl to find a menu the menu that allows these options to be set which should be in the right hand panel.
Eventually I discovered that if I boot the DJI controller while the Mavic 2 Enterprise Dual drone is turned off, the right hand panel reveals options to set a codec and also the frame rate in the "video size" menu item. Unfortunately attempting to select a codec or frame rate in this state has no effect. Nothing can be selected and set.
If I turn the Mavic Drone on, the controller returns automatically to the splash screen. Selecting "Pilot" and returning to the menu (on the right side panel) there is no selection for a codec available . In the selection for "video size" where you can normally select a frame rate the only choice is 30fps.
Just to re-iterate, when the drone is turned on the options to set codec and frame rate do not appear.
When the drone is turned off the selections appear but the software won't accept any of the selections.
I have updated the firmware and the problem persists.
|
|