jeffridj
lvl.1
Flight distance : 438806 ft
United Kingdom
Offline
|
cheddar-man Posted at 11-4 00:21
Soldering is not rocket science, have a go, but make sure you get the wires in the right place or the motor could run the wrong way!
Did he use the right motor.....
If the wires from the motor to the esc have been cut in the middle you will find that they are enamelled wires which are difficult to remove the enamel in order to solder them properly. This was exactly the same problem that i had. Its very much worth a bit of time cleaning the enamel off and soldering the wires correctly providing the motor is good and is the correct one. Good luck. |
|