Does anyone know the cause/solution for thermal imprints like these? (The heat signature of the tree seems to have temporarily burned into the thermal images leaving its imprint even when a body is blocking the tree from the view of the thermal lens). The imprint eventually fades - only to get replaced by heat signatures of the objects in the new FOV... rendering data collection near impossible.

Do FCC, this maybe refresh the sensor

Hey.
I think I have the same problem. Did you find a solution for?

I hope it would help me

fansa82ef67b Posted at 2021-11-24 19:04
Do FCC, this maybe refresh the sensor

After I Refresh the Sensor with FCC a new image is still burned. Any further solution?

fansa82ef67b Posted at 2021-11-24 19:04
Do FCC, this maybe refresh the sensor

After I refresh with FCC a new image is burned. Any further solution?

Thanks

fansa82ef67b Posted at 2021-11-24 19:04
Do FCC, this maybe refresh the sensor

After I refresh with FCC a new image is burned. Any further solution?

Thanks

I've seen this effect on other FLIR thermal cameras (Lepton 3.5) where the shutter for calibration was stuck. May be a physical thing to be checked by DJI service.

SimonID Posted at 5-27 01:08
I've seen this effect on other FLIR thermal cameras (Lepton 3.5) where the shutter for calibration was stuck. May be a physical thing to be checked by DJI service.

Thanks for your help. I think there is no other way then sending the drone to DJI.

I have the same problem, any Solution please?
Write here : wicom.pq@gmail.com

wicom.pqgmail.com Posted at 9-15 21:34
I have the same problem, any Solution please?
Write here : wicom.pq@gmail.com

Send it back to DJI. You're sensor is burnt.