b-ori
lvl.1
Israel
Offline
|
I haven't flown my Mavic Air for a while. When I turned it on a few days ago, everything looked fine, except the gimbal, which was pointing to the right / down and a bit tilted.
The gimbal still works (reacts to moving the mavic air), but it tries to "center" too much to the right to the point where it says (all the time) gimbal motor overload.
I tried calibrating the gimbal, but the process starts, shows it's at 10% and then stuck forever (I can't even exit the flow on the phone).
Here's a short video that demonstrates how the gimbal works: https://youtu.be/k0u-ukKX89Q
Any suggestions on what can be done? The drone didn't suffer any mechanical damage, and generally, everything seems to work (I replaced a fan that stopped working, and it took some time until I got the fan and had time to replace it).
|
|