Hi DJI team, i remember that in your first RS2 firmware, we could recharged raveneye in sametime than principal battery with one single cable plug in RS2 battery and without the need to power on RS2.
Now with your lastest firmware, we can't do that, we have to plug one cable in RS2 battery and one cable to raveneye when RS2 power off.
I saw that in standby mode with only one cable pluged to RS2's battery, we can recharge raveneye but only during severals minutes....(10 minutes) it is not as good than before.
It is far better to shutdown RS2 and plug only one cable on his battery to recharge everything.
If you could re-impliment this with newer firmware, that will be very cool.
Thank you.
An exemple, now with your lastest firmware, we have to unplug raveneye to RS2 cable and plug another cable for recharge it. That is not very smart no?
Rud.  

Could you post a picture how you charge RavenEye?

pawelPL Posted at 11-23 17:32
Could you post a picture how you charge RavenEye?

With the first firmware, we juste have to switch off rs2 and raveneye, plug usb recharge cable to rs2 battery (usb at the bottom of rs2 battery) to charge everything (rs2 battery and raveneye battery) without unplug any cables.Now with the last firmware, we have to turn on rs2 switch off raveneye and double clic on power button to be in standby but after 10 minutes there is a full standby mode who stops charging. So now, if we want full charge on RS2 and raveneye we have to switch off rs2 and raveneye, unplug the cable of raveneye, an plug power on the two.