How do I rollback dji mavic 3 firmware
I have run into a problem with my Mavic 3 where the camera switches from Video to Still about every three seconds. This just started after I updated the firmware. The drone flys perfectly fine and appears that the camera is the only issue, I was hoping to roll back the firmware to see if that would sove the problem before I sent the drone back.

I can't see an option in DJI Assistant.

I am open to any suggestions that someone might have.

Thank you in advance!!

Hi! You might be better off posting your question in the 'products' section of this forum.  That is way more active.    -   https://forum.dji.com/forum-129-1.html

DAFlys Posted at 11-27 01:14
Hi! You might be better off posting your question in the 'products' section of this forum.  That is way more active.    -   https://forum.dji.com/forum-129-1.html

Thank you...

5one7 Posted at 11-30 08:59
Thank you...

No probs sir.