After updating RSC2 FIRMWARE 01.04.00.00, the tilt and roll axes work normally, but the deadband and speed settings of the pan axis do not work at all. And it's not smooth, and it goes back right away as soon as it moves.

In this state, shooting cannot proceed.
Unless DJI releases a new FIRMWARE or fixes it, RSC is unlikely to be usable.

A video was also recorded. I hope you get a quick fix on this part.

https://vimeo.com/653093135

Thanks for the warning!

Montfrooij Posted at 12-5 04:36
Thanks for the warning!

of course !!!!!!!

fans888d9f71 Posted at 12-5 04:38
of course !!!!!!!

Did you find a fix?

Montfrooij Posted at 12-5 04:38
Did you find a fix?

No, there is no way because the firmware itself was made incorrectly in dji. In addition, consumers cannot make a method because it is only possible with a mobile phone rather than connecting to a PC and updating it. I think it's important to let the dji know this quickly.

fans888d9f71 Posted at 12-5 04:46
No, there is no way because the firmware itself was made incorrectly in dji. In addition, consumers cannot make a method because it is only possible with a mobile phone rather than connecting to a PC and updating it. I think it's important to let the dji know this quickly.

Maybe post about it in the 'products' section.

fans888d9f71 Posted at 12-5 04:46
No, there is no way because the firmware itself was made incorrectly in dji. In addition, consumers cannot make a method because it is only possible with a mobile phone rather than connecting to a PC and updating it. I think it's important to let the dji know this quickly.

That is way more active.

Montfrooij Posted at 12-5 05:06
That is way more active.

me too
!!!!!

fans888d9f71 Posted at 12-5 05:15
me too
!!!!!

Good

Thanks for sharing.