BarnSwallow
lvl.4
Flight distance : 5076896 ft
United States
Offline
|
Working with a Protek 35 drone with the DJI CADDX Vista component. All firmware up to date. I'm a total newbee.
1) Green lights on drone and DJI radio but no response when moving the controls, including moving both sticks down and in.
2) First time I tried Betaflight it connected just fine. Now, it gives me a Serial Port failed to open error. Since it did work, I assume I don't have a driver problem. When I plug in the USB I do not get the beeps Windows does when it recognizes a new USB connection. I suspect a wire is loose on the board. I've tried different USB ports, different cables, rebooting. Link between DJI radio and drone shows green. The first time I used Betaflight, I didn't disconect properly, just pulled the power on the drone, could that have messed up something? I pulled the power because the drone started beeping, I don't know why it was beeping, I thought perhaps the battery was low. I'm a total newbie to this so it's probably something dumb.
|
|