hi everyones and a happy xmas to you all.

only into my second flight with the mavic 3 and i have some faults with it.

once i take off and the drone is in the air, it rotates on its own. done a gimble and imu calibration but still the same.

when taking a photo and i tap the rc pro screen or use the focus shutter button to get it in focus the drone moves and i have to navigate it back to the original postion were i was taking a photo.

i have linked the rc pro with the mavic 3 but constantly getting error messages that the rc pro is not bound with the mavic 3.

all my photos are tilted. done a gimbal calibration but still the same results.

on the rc pro i have tried to find were i can do a factory reset for the mavic 3 and the rc pro controller.

all firmware is all up to date.

thanks and best wishes to you all.

Hi! You might be better off posting your question in the 'products' section of this forum.  That is way more active.    -   https://forum.dji.com/forum-129-1.html

DAFlys Posted at 12-25 01:01
Hi! You might be better off posting your question in the 'products' section of this forum.  That is way more active.    -   https://forum.dji.com/forum-129-1.html

thank you so much for the link. appreciated.

phil-142 Posted at 12-25 05:13
thank you so much for the link. appreciated.

No probs Sir.