I am trying to perform the latest Inspire2 FW and during the update it fails at the same exact place.  Tried updating from Assistant, iPad via GO 4, and lastly via Crystal Sky with Go4.  

During the Crystal Sky update process it gives you a status of what’s being updated.  Everytime it gets to the “camera” it fails.  Using an X5s gimbal / camera.

From reading on here I’m not sure what steps to take.

Hate to send in for “repair”… anyone experience this and find a solution?

Thanks!

It’s gets here.  Keeps getting to 19%.  Goes back to 8%.  Then 19%.  After a few minutes of this it seems like the camera / gimbal / aircraft reboot.  Gets to Camera 18% and then fails update.  Everytime.  I’ve tried this restart sequence no less than 20X now.  Cost me hours and still not able to complete the FW update.

I have a brand new backup Inspire2 that I just tried the update on and it fails as well.  Gets to camera and barfs.

UPDATE.  I downgraded the Inspire2 two revisions.  Camera not attached.  Power cycled and added camera.  It updated everything to Ver 01.02.0400 and then flawlessly updated to Ver 01.02.0600.  Maybe camera was not updated and too far back for latest FW to update?