I just fired up my Air 2S and as soon as the RC Pro came on line it did a firmware update. Then the 2S had to update. Then went flying, no change as far as I could tell. The last time I flew was yesterday. When I put it up, I checked all the settings before powering down and did not notice anything different. Anybody know why the new update?

Hello there Mobilehomer. Good day and thank you for sharing these information with us. Again, thank you for your support and keep flying.

DJI Stephen Posted at 2-7 20:12
Hello there Mobilehomer. Good day and thank you for sharing these information with us. Again, thank you for your support and keep flying.

Stephen, your response did not answer my question. WHAT DID THE UPDATE DO? Why?

Mobilehomer Posted at 2-8 09:50
Stephen, your response did not answer my question. WHAT DID THE UPDATE DO? Why?

Was there a FW number?

hallmark007 Posted at 2-8 14:22
Was there a FW number?

Not a new one.

Did you have the RC Pro paired with a Mavic 3? I know the regular RC-N1 controller does a FW update depending on which drone is paired (between A2S and A2), so maybe the RC Pro does this as well for the M3 and A2S.

RobZilla Posted at 2-8 14:46
Did you have the RC Pro paired with a Mavic 3? I know the regular RC-N1 controller does a FW update depending on which drone is paired (between A2S and A2), so maybe the RC Pro does this as well for the M3 and A2S.

No, it came with the Air 2S FMC. I did all the updates as soon as available. So this is a new one with no new number.