Very excited to get my RS 2 back from repair today. They repalced IMU Main Controller Board. Everything seems good except when I try to connect to Raven Eye via the Ronin app. The WiFi connects just fine and I get a green light on the Raven Eye. I also have a nice clear view of camera feed. But when I try to do an Auto Tune from the app it tells me. 'Connect gimbal before using this function.' I get this message with Blue Tooth 'Off' or 'On'. Also, I can not make any adjustments to the Motor seetings from the app when using Rave Eye. Everything works fine if I am not using Raven Eye.
Screen grabs.   



The Gimbal Firmware is now: 1.4.11 (14110)
My Ronin app for iPhone is up todate.
My iPhone is operating under iSO 15.3.1

Very excited to get my RS 2 back from repair today. They repalced IMU Main Controller Board. Everything seems good except when I try to connect to Raven Eye via the Ronin app. The WiFi connects just fine and I get a green light on the Raven Eye. I also have a nice clear view of camera feed. But when I try to do an Auto Tune from the app it tells me. 'Connect gimbal before using this function.' I get this message with Blue Tooth 'Off' or 'On'. Also, I can not make any adjustments to the Motor seetings from the app when using Rave Eye. Everything works fine if I am not using Raven Eye.
Screen grabs.   



The Gimbal Firmware is now: 1.4.11 (14110)
My Ronin app for iPhone is up todate.
My iPhone is operating under iSO 15.3.1