Hi Folks!

Thank you very much in advance for taking the time to help me. I have a Phantom 4. At startup, the screen shows a red light that says IMU Calibration Requested. If I go to sensors and select calibration, I get errors on IMU 1 (auto orientation error) and IMU 2 (temperature out of range).

I tried to reset the firmware to factory default, but nothing. The gimbal is a bit bent, but I've been using it for years without any problems.

Many thanks once again!

Welcome El Chamico : I recommend you do the same via PC using Dji's assistant

https://www.dji.com/es/downloads ... t-dji-2-for-phantom

JetSam Posted at 3-28 06:47
Welcome El Chamico : I recommend you do the same via PC using Dji's assistant

https://www.dji.com/es/downloads/softwares/assistant-dji-2-for-phantom

I did, updated the new version V02.00.0810 and it throws an error.

El Chamico Posted at 3-28 07:45
I did, updated the new version V02.00.0810 and it throws an error.

Have you not used your device for a long time?

JetSam Posted at 3-28 08:00
Have you not used your device for a long time?

I use it twice a year, but it has been working really well.

El Chamico Posted at 3-28 09:05
I use it twice a year, but it has been working really well.

these problems usually appear after a period of non-use, I recommend a complete review of your device.

Hi, there. Sorry for the inconvenience. Is there any error code when calibration fails? When calibrating on the first side, do not shake the aircraft and keep it level, or the temperature calibration may fail. Please try to power on the drone again. If a prompt stating that the IMU calibration is required is still shown, calibrate the IMU again. If the prompt is not displayed, IMU calibration does not need to be performed.