spyroot
lvl.1
United Arab Emirates
Offline
|
Folks,
I think there is a bug somewhere in RS2. It is either power delivery or a software bug, or something else.
When RS2 is connected to Sony A7iv, sometimes it moves the camera to a state when
the camera stops responding.
It blinks red (Sony indication of error), and the camerais not responding. (I believe it moves a
camera to some safety protection state.)
Note:
- if you disconnect all cables.
- shutdown
- wait
(In two cases, I had to remove the battery twice). ( Note it is a new camera)
- I tried to reproduce and find a root cause.
a) Trying to figure out a sequence of start i.e. RS2 first /start camera second. or vice versa.
- The second case I tried to check.
If RS2 is changing while the camera is off.
If RS2 is changing while the camera is on.
Note I couldn't reproduce. And it looks completely random.
A person with a similar issue.
https://forum.dji.com/forum.php?mod=viewthread&tid=260629
It happened before the update. It is the same issue now after I upgrade to the latest firmware camera 1.0.1 (the latest Sony.
Update RS2). I observe the same issue.
|
|