Hi swarm intelligence,
my ForcePro via wireless receiver is sending movement data to Ronin2 (viewable with RoninApp under .configuration/remote. in channels) in one channel even with no movement at all. (jumping numbers beetween 1 and 3) which leads to strong drift of gimbal in according axis.

forcepro is in speed-mode.

in position mode no wrong data is send.

(but remote sensitivity and delay of operating in position-mode is not satifying at all).

so, how can you avoid the wrong false mis-data of the forcepro?

when forcepro is shut off, gimbal is not drifting at all.
is calibrating of forcepro somehow possible? (not of compass, of sensors)
thanks for your thoughts.


daniel, berlin, germany

I have same issue with gyro control of DJI transmission combo high bright monitor. Did you drive your problem ?

No. I sent it in 2times to DJI to repair but they did not fix it. I got back the same device again, paid for some electronic board exchange and found the same fault.
I guess the quality of the gyro sensors is not always the same in the devices (others of friends work perfectly), the accuracy is changing from device to device. which is not good and no recommandation for the force pro.