Hi,

I have a zenmuse Z30 Which suddenly and for no Reason has stopped working.  This was not after any updates and was simply between flights.

The Z30 has started spinning from end gimbal end stop to end stop, it does this three or four times then pauses gives a little squeak before continuing the process.  It will continue to do this until the drone is powered down.  I have attempted to re-install firmware and even roll the firmware back.
The camera however doesnt appear to recognise any firmware update or rollback at all.  I have formatted the SD card and put old and new firmware on it (not at the same time).

Any suggestions sould be greatly appreciated.

Sorry to see you never got an answer. it's two years ago so I presume you have solved it. Do you still have the Z30? What was the drone model it caused those troubles with?