Just finished my new cooling solution for the times when the props are off and I just want to fiddle with it.

Cool, lol, whats the under side of the unit look like please?

Your prints looks perfect, which filament is this BTW?

Nice concept.

Nice bit of crafting there. Can you power it from usb-c? Might be useful as a non flying camera. Put a tripod mount on the bottom.

I just park mine here. I'ts not much use for shooting from but it does for messing around in the options.

Good idea.
In which direction does the airflow go? Into or out of the drone.

Bashy Posted at 5-26 04:30
Cool, lol, whats the under side of the unit look like please?

MySky Posted at 5-26 05:48
Good idea.
In which direction does the airflow go? Into or out of the drone.

It blowing air through the drone same as the props will do.

Geevo Posted at 5-26 05:29
Nice bit of crafting there. Can you power it from usb-c? Might be useful as a non flying camera. Put a tripod mount on the bottom.

I just park mine here. I'ts not much use for shooting from but it does for messing around in the options.

Good idea. Its just normal usb atm instead of usb c

Nazar78 Posted at 5-26 04:42
Your prints looks perfect, which filament is this BTW?

Prusament PLA work very good on a prusa printer

RappeFiets Posted at 5-26 07:08

Excellent, thank you

RappeFiets Posted at 5-26 07:10
Good idea. Its just normal usb atm instead of usb c

It's great.

Only said usb-c as I didn't know what the voltage or power draw was but guess it will still run fine with reduced power at 5v and at less than 100 mA would imagine it will run for ages off even a small power bank.

Very creative DIY cooler.  

Hello there RappeFiets. Good day and thank you for sharing this interesting cooling accessory that you have created for your DJI Mini 3 Pro. This is very innovative. Have a safe and a happy filming always.

Any underside laptop cooler works better and is far less expensive. I used this one: https://www.amazon.com/gp/produc ... e?ie=UTF8&psc=1

can we get the stl file somewhere?