Hi there,

question about RC...
So with new controller DJI RC (RM330) we have O3 while with DJI RC-N1 (RC231) it remains in O2?

What is the thruth?

No, both remotes have the same exact specifications in terms of transmission power, resolution and bit rate.  They both are considered O3 by DJI, and other than the chipset are very similar.

Both remotes are O3 - the RC-N1 switches firmware when you bind to another aircraft that uses a different Occusync version.

As of right now, we don't know if the DJI RC has the capability to switch, as its currently only compatible with the Mini 3, so only works with O3.  Presumably, when they make it compatible with the Mavic 3, as promised, it will likely support O3+

Hi there. Thank you for reaching out. The DJI RC-N1 is well equipped with O3 or Ocusync 3.0. Kindly please refer to the image below for your reference. Thank you and have a good day ahead!

So ok...this means that N1 can "works" with 40Mhz of bandwidth as from O3 specs? ...and where can i read some more details about O3?