Tanasit
lvl.3
Flight distance : 145509 ft
United States
Offline
|
No I did NOT.
But I think I finally figured this out today. Essentailly, you do NOT need to connect the Mini 3 with the phone via Wifi but with Bluetooth only.
Before you take off, make sure BOTH the DJI RC and the Mini 3 are connected to the phone via Bluetooth.
See steps below:
This is for at the field without Wi-Fi signal, so the iPhone will be used as the “Hot Spot”.
1. Turn on iPhone
2. Turn on DJI RC
From RC Home page press:
Swipe down twice to setup then press “…” (top right)
Connection device
Set up Bluetooth
Turn on Bluetooth
Pair new device
Select iPhone
Go back to Network & internet
Set up Wi-Fi
Turn on Wi-Fi
3. Turn on Mini 3
Connect mini 3 to iPhone on Bluetooth
Both Mini 3 and RC should be connected to the iPhone by Bluetooth now.
If not connected go back to Set up Bluetooth above and
Pair new device: select Mini 3
On RC go to Go Fly then press “…” (top right)
Under Safety tab, select Unlock Geo Zone (scroll down on Safety tab)
Select aircraft and locking license and refresh
It should say “valid”
Or take off and follow screen prompt.
If error “Internet connection required” appears, go to iPhone and make sure that the DJI RC is connected to the iPhone via Bluetooth.Sometime, it got disconnected later!!!
Take off and follow screen prompt:
Check all boxes
Click OK, OK
Fly out to open area, stop
Update home point (set up, safety)
|
|