Snapster
lvl.1
France
Offline
|
I bought a Mini SE a couple of days ago. I’ve flown it a few times and this morning there was a firmware update.
I just tried to fly it again today. I was able to take a quick flight after I registered for DJI refresh. Now, I can turn the controller on, turn the drone on, get the message ready to fly, then the top line in DJI fly goes red and says RC not connected. The 4 lights on the controller are on and I can start the motors. I’ve not tried flying…. I can turn everything off then on again, but before I fly, the message comes up again. I’ve re paired the drone and handset, I’m using my iPhone SE Why does it keep disconnecting? I’m flying from a wooden deck, the same as I have since I bought it. |
|