The X1 tilt control stick is not working after I calibrate it. How do I reset to the original setting?

Pls try recalibrate X1 in Assistant software. Don't forget to click on ''Finish'' when it's done.

I tried and it doesn't work. Is there a way to reset?

Did you try calibrate in RC assistant software?

RC assistant software does not allow X1 calibration.
Only Assistance Software allows X1 calibration.

Vy -

Please run calibration via the RC assistant, make sure you see x1 move. Once you verify it moves there, then perform the x1 calibration in the phantom assistant.

Calibrate the remote in the rc assistant and move the gimbal tilt while you calibrate the remote and when you finish go in to the PT2 assistant and calibrate the x1

dekelkabeli Posted at 2014-9-30 00:26
Calibrate the remote in the rc assistant and move the gimbal tilt while you calibrate the remote and ...

Have the exact same issue. both the RC assistant and the PT2 assistant dont see the x1 handle. did you find a solution?

Here's a photo tutorial

Hello all,
My H3-D3 gimbal is not facing the front of my Phantom and is off by 45 degrees, pulsing slightly every few seconds.
I have used both the RC assistant and the phantom 2 assistant software to re-calibrate my gimbal but without success.
DJI recommended that I download the gimbal assistant software, which I did, but it does'nt recognize my gimbal. It is not a driver problem as both other software work perfectly. Help please

I have a phantom 1 and remote DJ6,
the x1 don't move in the assitant sofware RC.
What can i do ?
i installed driver, software RC and nazamv2,
everything works except le x1
what can i do ?