Hi there,

i hope i've found the right forum to post this, but anyways...
i have a f550 frame with the Naza M V2 Flight system in it, including GPS, iOSD, PMU, etc etc
however, i've also always had the Zenmuse H3-3D Gimbal on it, and until yesterday it has been working fine, but now, whenever i plug the hexacopter in (or just the gimbal after the copter already has power) it just starts shaking and moving wildly in all directions, with no obvious intention behind it. when i connect it via USB to the zenmuse asistant (while it is shaking btw) it does connect, however it only shows one tilt slider, nothing else (not sure how it should look since i never used the assistant before).

can anyone help me to resolve this issue?

and does anybody know a support-email i could write to it about?

thank you all very much in advance

Hi there,

i hope i've found the right forum to post this, but anyways...
i have a f550 frame with the Naza M V2 Flight system in it, including GPS, iOSD, PMU, etc etc
however, i've also always had the Zenmuse H3-3D Gimbal on it, and until yesterday it has been working fine, but now, whenever i plug the hexacopter in (or just the gimbal after the copter already has power) it just starts shaking and moving wildly in all directions, with no obvious intention behind it. when i connect it via USB to the zenmuse asistant (while it is shaking btw) it does connect, however it only shows one tilt slider, nothing else (not sure how it should look since i never used the assistant before).

can anyone help me to resolve this issue?

and does anybody know a support-email i could write to it about?

thank you all very much in advance