Hi guys,
I have a problem in programming the lidar mission in the UCGS program for my drone matrice 300 rtk  equipped with L1 lidar.
I program the mission and the drone follows the route it must perform but doesn't rotate the sensor to 90 degrees as when I use the application dji pilot 2 and consequently when I process the cloud in dji terra I don't see the dense cloud.
Does anyone have experience with L1 lidar and Ugcs?

Hi, you might be better off asking this question in the products section of the forum (that is much more active).
https://forum.dji.com/forum-129-1.html