I recieved a phantom 2 in they mail today. I began to go through the set up and put up my gimbal and attache all of the wiring. But once I turned on my phantom, the gimbal would not collaborate. The gimbal wouldn't even move at all. I looked online and it seems like not many have had this problem otherwise I would see what their solution was. I have tried updating all of the firmware but still nothing! Please help! Also the gopro shows a light that it is connected to the usb so that means there is some signal in the wiring.

reset ur firmware

Please connect to the Assistant software, go to Upgrade, and check if there is ZEN IMU info. If not, please reload the gimbal's firmware.

Got it to work, Thank you!