Hello DJI,

Is it possible to add a channel in the control s-bus, to manage the sleep mode (or autolock)?
Also, is it possible to know which channel is available?
We already know that
CH1 : PAN
CH2: TILT
CH3 : Not used
CH4 : ROLL
CH5: Nothing or capture?
CH6: Nothing or capture?
CH7: Switch mode (between custom and PF ?)
CH8: Nothing or capture?
etc etc.

We don't have a recenter channel (while the ronin 2 allows it).
We know its possible to add sleep mode via the two S-BUS ports, because there is a button 'sleep' on the additionnal handle sell buy DJI.

Thanks a lot !

Hello there brieucLM. Thank you for reaching out and for giving out these information. I will forward these information to the designated DJI Department for attention. Thank you.

DJI Stephen Posted at 9-7 19:46
Hello there brieucLM. Thank you for reaching out and for giving out these information. I will forward these information to the designated DJI Department for attention. Thank you.

Thanks a lot for you anwser !

Do you have news about the designated DJI dpt ?

thanks !