First, let me apologize if this is covered somewhere in the forum - I simply cannot find it...hate to annoy folks with redundant questions. And it is certainly not in the User Guide for the aircraft.

Today, I finally (properly) updated my Pilot App on the very capable tablet I have used from the beginning. The tablet settings have me in the US time zones and the Language and Input settings of the device are US as well.  Now when I go to set up the Image Transmission Settings, and touch the Custom radio button (vs Auto), it immediately lights up then changes instantly to highlight the Auto button. In other words, I simply cannot seem to get Custom to work anymore. What is going on?

Can someone please tell me what I need to do to get the Custom button to stick - what have I missed?

Note that below the Channels, the slider for Image Transmission Quality works fine. There are no major issues with flying the P3, but I do need to pick a better channel than the "default"  Ch13.


Thanks for your help.
Phil

Phantom 3 Advanced
300A Controller
Samsung Tab Pro 8.4 (Android 4.4.2)
Pilot App 1.2.0 (As of today as noted - Of course hope to have "GO" Soon)
Firmware 1.2.8

Is the P3 turned on when you are trying to set it to custom?

Rigworker Posted at 2015-8-9 14:31
Is the P3 turned on when you are trying to set it to custom?

Ummmm... No. Is that the problem?!
What a dummy I am. Very late here now, but will do first thing tomorrow.

Yes, the bird must be lit up, and ready for take off.
The Home Point has been Registered, Please Check it on the Map. ;-)

Many of the App settings, can only be adjusted, while the model is running.

RedHotPoker

YEPPER ! That nailed it.
Thank you guys so much!

My Samsung tablet won't connect to satellites

kgreen13299 Posted at 2015-10-12 15:48
My Samsung tablet won't connect to satellites

What tablet is it? Does it even have GPS?