Hi.
I´m using a Naza V2 (4.02) and tried to use my new Frsky X8R Receiver. Everything works fine if i force failsafe with a Switch of the transmitter. But if i switch off the transmitter, the U-Channel (CH7) has allways a value of 491. I tried failsafe of the Receiver itself, no pulses and custom setup. Channel 1-6 follow the preprogrammed failsave values, but not CH7. I changed from S-Bus to "Tradition" and the failsave works as expected. This Looks like a bug in the Naza Firmware. I´m not the only one with this Problem, look here:
http://fpv-community.de/showthre ... lsafe-DJI-Naza-Lite
Is there a Workaround or is there a Chance that this bug will be fixed? Otherwise i´m not able to use the pwm outputs for other funktions.
Regards

Hi.
I´m using a Naza V2 (4.02) and tried to use my new Frsky X8R Receiver. Everything works fine if i force failsafe with a Switch of the transmitter. But if i switch off the transmitter, the U-Channel (CH7) has allways a value of 491. I tried failsafe of the Receiver itself, no pulses and custom setup. Channel 1-6 follow the preprogrammed failsave values, but not CH7. I changed from S-Bus to "Tradition" and the failsave works as expected. This Looks like a bug in the Naza Firmware. I´m not the only one with this Problem, look here:
http://fpv-community.de/showthre ... lsafe-DJI-Naza-Lite
Is there a Workaround or is there a Chance that this bug will be fixed? Otherwise i´m not able to use the pwm outputs for other funktions.
Regards