djimunichzefix
New
Germany
Offline
|
timboritus Posted at 10-28 07:53
So this took me a long time to figure out because there was ZERO information about any of this documented. Even the youtubers didn’t mention a lot of these complications.
-LIDAR currently doesn’t work with the DJI Transmission + RS3 Pro. Disappointing, I know. Best info I got was from PotatoJet on youtube mentioning that compatibility would come with a firmware upgrade in the “future”. That was also one of the reasons I purchased the transmission too.
-Additionally, there’s not supposed to be any physical connection between the DJI Transmitter and the RS3 Pro. The USB port on the Transmitter is only to be used for connecting to a PC for upgrades. If you watch any of the youtube videos showing the RS3 Pro with the Transmission system the usb port is not in use. Somehow it, “just works.” Most of the ones I’ve seen use the LEMO to USB-C cable for powering the transmitter ONLY. You’ve got it connected correctly you’ll just need to chose between using the LIDAR in the 3rd port (bottom) or using the port to power the transmitter.
actually there is a way to get it to work if you connect DJI Tranmission to the last USB Port, and then connect the Focus motor to the middle USB C port and run a USB C Cable from the motor to the Lidar
(dont use the cable with the block in between)
depending on which port you connect the LIdar on the Focus motor, you get either auto focus, or even Active tracking, but you wont see an image on the DJI Screen and with actov tracking the screen seems to behave weirdly.
Itßs kind of experimental, but it shows that it´s able to work. |
|