flying yesterday with no problems and 17 sats attached, then for some reason while in hover the avata started to fly backwards on its own. i was using the motion controller and i know you cant flybackwards with this, anyone else had this problem.

strong wind??

guidodg Posted at 10-17 06:16
strong wind??

no wind as i was in old aircraft hanger

Satellites reporting wonky inside said hanger.

was it very dark?

Happened with mine as well. I was close to the ground and the surface was uniform, no structure for the down sensor to fly the Avata correctly.

Hi there. Thank you for reaching out and we're sorry for the trouble. Can you please confirm if this happens also in a different location? Can you please try to fly to a different location to see if the issue persists? Also, can you please confirm what specific height are you at when you experience this issue? Please keep us posted. Thank you.

Hi . I have the same problem. I don’t know how to fix. Whenever I am trying to fly it’s always flying backwards ..

djiuser_ctnnpBf9U3ZM Posted at 7-27 09:37
Hi . I have the same problem. I don’t know how to fix. Whenever I am trying to fly it’s always flying backwards ..

Hi there,
thank you for reaching out.

Before we can assist you, could you please check if the GPS signal is strong? Try moving to a different location with no wind to test the signal. Also, inspect the propellers and motors to ensure they are in good condition. Verify if any motor behaves abnormally when the propellers are not attached. Then, make sure there is no magnetic interference. It's best to place the aircraft on level ground for IMU and compass calibration. Check if the control stick is being pushed and if its movement is correct. If needed, calibrate the remote controller.

If the issue persists, kindly let us know. Thank you.