Middle Tenn State UAS
lvl.1
Flight distance : 164816 ft
United States
Offline
|
Hi I am having the same error with Avata.
When trying to switch into manual mode, “UAV too high/far” error pops up, M mode is not being enabled.
It happens on any distance, including when I hover in a couple of meters far and high from takeoff point.
It used to successfully switch in manual mode in September, but then at some point it stopped switching into M mode.
I tried the following and it did't fix the M mode problem.
1. Remote controller sticks calibration
2. Linking different RC, with calibration
3. Enabling and disabling M mode attitude limit
4. Flying within and outside Flysafe warning zones, including totally free-of-any-restrictions zones.
5. Different aircraft firmwares, including oldest and the newest.
6. Different goggles (2 and V2)
7. Trying going into manual mode closer and further away from takeoff point
8. Playing with Altitude and Distance limits, changing them within all possible ranges.
Height and distance OSD readings are accurate and change accordingly to the flight path of the aircraft
I am flying DJI Avata for Middle Tennessee State University, which is an approved member of QEP program, so I even have Geozone unlocking for this aircraft.
I have tried M mode before and after unlocking.
Please help me making M mode back to work!
Thank you
Alexander Fomenko, UAS Lab Coordinator, MTSU |
|