Electronic Image Stabilization (EIS).
The product supports RockSteady technology.
Libra
Approx. 8.3 g (including coaxial cable)
Air Unit module
Libra
Air Unit (without Camera Unit): Approx. 28g Air Unit (including Camera Unit): Approx. 36.4g
Antenna: Approx. 3g
Dimensions (L x W x H)
Transmission module: 32.5 x 30.5 x 14.5 mm (L x W x H) Camera module: 21.2 x 20 x 19.5
mm (L x W x H) Coaxial cable: 115 mm (length ) 3-in-1 cable: 100mm (length) Antenna: 85mm
(length)
Communication frequency
2.400-2.4835 GHz (RX only) 5.725-5.850 GHz (RX and TX) [1]
Transmission power (EIRP)
FCC: <33dBm CE: <14dBm SRRC: <30dBm
Live view quality and end delay
[2]
With DJI FPV Goggles V2: 810p/120FPS video transmission quality: less than 28ms latency.
810p/60FPS video streaming quality: less than 40ms latency. With DJI Goggles 2:
1080p/60FPS video streaming quality: less than 30ms latency. 1080p/60FPS video streaming
quality: less than 40ms latency.
video transmission range
[3]
10km (FCC), 2km (CE), 6km (SRRC)
Flight controller software supported
Compatibility with flight controller software that supports Betaflight. Please see the product
FAQ for more information.
input voltage
7.4-26.4V
Working temperature
-10°C to 40°C (14°F to 104°F)
Channels
Auto mode support Manual mode support: 40 MHz: 1 channel; 20MHz: 3 channels; 10MHz: 3
channels;
nOxxxx Posted at 11-23 02:15
In two different places on the DJI website, I found conflicting answers to the following question:
Does the DJI O3 Air Unit support photo taking? Where is the truth?
https://www.dji.com/pl/o3-air-unit/faq#2-7
really strange....
maybe is not the objetive for a FPV camera and u can always take screenshots
I read a DJI publication that suggested the air unit be mounted direct to CF to aid with cooling. Would it make sense to use thermal paste? I have no idea if thermal paste directly on CF is a bad idea?