Hi team, got two questions here:
So I was scrolling on the official DJI FPV website I noticed what we see on the attached picture:
So the new DJIFPV units are being sold with O3 air unit incorporated, is that correct?
If so, is it possible to upgrade previous units to O3?

2nd question: with the current firmware is it possible to use Gyroflow for stabilization already or not?

Thanks!
Andre Nobrega

That's a funny one. I didn't get the impression they had any plans for that drone as they didn't address any of our suggestions...

That is weird. But who knows.

The DJI FPV has always been O3, you can go back and look using this link from April 2021 and see for yourself.

DJI FPV [Internet Archive]

DubSound Posted at 12-4 05:32
The DJI FPV has always been O3, you can go back and look using this link from April 2021 and see for yourself.

DJI FPV

so can we actually replace the camera by the latest o3 one? which is the same as the avata?

airborne.clips Posted at 12-4 13:19
so can we actually replace the camera by the latest o3 one? which is the same as the avata?

For the DJI FPV you just swap it with the DJI FPV camera, the Avata camera isn't compatible with DJI FPV due to being a totally different physical design.

Your camera is just a camera, the O3 technology is in the RF part of the PCB modules in the drone and not the camera itself.