I recently got a Mavic 3 Classic with a DJI remote that has a built-in screen (the gray one, not the  black one).  I cannot get the drone or homepoint to appear on the map.

Where do I find the setting to get them to show up?

Thanks,

rgames

Hi there. Thank you for reaching out. The Home Point can be updated before takeoff as long as the aircraft receives a strong to moderately strong GNSS. If the GNSS signal is weak then the Home Point cannot be updated. Please try to take off in a different location to see if the issue persists. You may access the link below for the manual of the DJI Mavic 3 Classic. Thank you for your valued support.

https://dl.djicdn.com/downloads/ ... anual_v1.0_ENII.pdf

Hi.  Thanks for the reply.

The homepoint does get updated but it does not appear on the map.  I get the "Homepoint has been updated" audio but it does not put a dot on the map like it used to with my past DJI drones.

My question is: how do I make the homepoint appear on the map?

Again, my problem is not with the homepoint getting updated.  My problem is that it does not appear on the map.

And the drone position does not appear on the map either.  Neither the drone nor the homepoint appears on the map.

Hopefully that is clear.

Back out of the camera view and then go back to it.

Switch to radar view and see if you see it then.

rgames Posted at 12-10 17:43
Hi.  Thanks for the reply.

The homepoint does get updated but it does not appear on the map.  I get the "Homepoint has been updated" audio but it does not put a dot on the map like it used to with my past DJI drones.

if possible upload a screen recording for this issue

video explains more than text  ;-)

cheers
JJB