SJurick
lvl.2
Flight distance : 207159 ft
United States
Offline
|
Just installed a new O3 air unit into my Geprc Mark 5 which was previously running BetaFPV ELRS and had a DJI Air Unit for video. Now after unplugging the old air unit and replacing with the O3 system, my ELRS receiver stays on like it's bound, but no inputs are received from TX. I unplug the DJI O3 from the FC and everything works fine. So I believe the O3 is competing wtih the ELRS receiver but don't know how to fix this. I will not be using the O3 for control, only video as I did with the older air unit.
My Betaflight ports are:
USB VCP is defaulted to ON under Config/MSP
UART1 is ON under Config/MSP
UART2 is ON under Serial RX
UART4 is ON under Config/MSP
My BetaFPV ELRS RX is connected to UART2
Not sure who has UART1 and UART4
Any help would be appreciated.
Steve
|
|