Just installed the card in the drone, I read often it is a nightmare to install and remove. Installing was OK, I now have shots on it (in principle... at least it was detected and selected in the App for my very first test-flight).

Hoveve, I find no way to remove that pinche card from there ...  Is the design so bad in this regard, or there's a trick I have not found ?

Ahh yeah, I've heard that's a pain. I'd recommend getting some tweezers and using that to push the card in and that'll "unlock" it so it pops out. Another solution might be to try using the stiff cardboard from some packaging, if it's able to fit.

Hi there. Thank you for reaching out. Kindly please refer to this thread https://forum.dji.com/thread-265115-1-1.html as our fellow DJI Pilots provide their suggestions about the tool they used to remove the SD card of the DJI Mini 3 Pro. Should you have other inquiries, please don't hesitate to reach us. Thank you for your valued support.

w33t Posted at 12-17 16:31
Ahh yeah, I've heard that's a pain. I'd recommend getting some tweezers and using that to push the card in and that'll "unlock" it so it pops out. Another solution might be to try using the stiff cardboard from some packaging, if it's able to fit.

Thanks a lot ! Indeed this worked.
Much appreciated

I use the edge of a credit card to push it in a bit and then it pops out.  

CrabshackPilot Posted at 12-17 21:37
Thanks a lot ! Indeed this worked.
Much appreciated

Good deal, glad it worked!

Almost all devices with a Micro SD card need to have the card pushed in and when you want it out, you have to push in again and it will pop-up.

DowntownRDB Posted at 2022-12-18 03:35
I use the edge of a credit card to push it in a bit and then it pops out.

That doesn't happen at all.  It's like there's no spring pushing back at all.  WTH DJI.  I guess I'll take it back and get a replacement unit. Poj

djiuser_f0WG4Bdvkvf0 Posted at 3-25 09:29
That doesn't happen at all.  It's like there's no spring pushing back at all.  WTH DJI.  I guess I'll take it back and get a replacement unit. Poj

Yeah, if you are getting no spring push back time to return it for repair or replacement.  

DowntownRDB Posted at 3-25 11:51
Yeah, if you are getting no spring push back time to return it for repair or replacement.

I had a similar problem, but the spring did work you just have to push it in right.

It is a bit of a fiddle but a good finger nail should be able to do it

There's a thread that discussing a removal tool here - https://forum.dji.com/thread-265115-1-1.html