DJI Gamora
Administrator
Offline
|
Hi, docwhiskey. Thank you for reaching out. Sorry to read that you're not able to connect your phone to the RC after the update. Kindly follow the troubleshooting steps below:
1. Please confirm if you have a protective case covering your mobile phone. If so, remove it and try connecting again.
2. Disconnect and reconnect the USB cable (from both the mobile phone and the remote controller), waiting 10 seconds before reconnecting the USB cable. If possible, retry with another USB cable.
① Please make sure that the cable is connected to the correct port (need to use the connection port for the phone's connection) as the picture showed:
② Please plug one end of the cable in normally and upside or further checking.
3. Restart the remote controller.
4. When using an Android device, if there is a prompt, be sure to tap [OK].
When DJI Fly is being used, USB Debugging must be enabled in the mobile phone system.
Enabling “USB Debugging” with an Android device. Please follow the steps below:
1. Go to [System Settings] > [About Mobile Phone].
2. Tap “Version Number” quickly 7 to 10 times (If the mobile phone has a screen-lock password, please input the correct password in accordance with the system instructions) until the mobile phone displays: “You’re in developer mode!”
3. Search for “Development” in the [System Settings].
4. Go to [Developer Options];
5. Slide the view up and down on the page until you see the “USB Debugging” option.
6. If the issue persists please try another device and try to switch to a device with a different operating system (Android <--> iOS).
Hope this helps. Please keep us posted. Thank you for your valued support. |
|