I have a Robomaster Development Board Type A. There's is a bulitin STM32F4 microcontroller in it. I'm Having trouble to deploy code in it. I'm still completely not sure how this thing works! Any suggestion?

Sketch uses 7416 bytes (1%) of program storage space. Maximum is 524288 bytes. Global variables use 844 bytes (0%) of dynamic memory, leaving 130228 bytes for local variables. Maximum is 131072 bytes.      

-------------------------------------------------------------------                        

         STM32CubeProgrammer v2.12.0                        

-------------------------------------------------------------------

Error: No debug probe detected.

Hi! You might be better off posting your question in the 'Developer' section of this forum.  That is way more active.    -   From https://developer.dji.com you can click Forum to access it or a direct link to it is - https://forum.dji.com/forum-139-1.html?from=developer

.............

DAFlys Posted at 1-22 06:21
Hi! You might be better off posting your question in the 'Developer' section of this forum.  That is way more active.    -   From https://developer.dji.com you can click Forum to access it or a direct link to it is - https://forum.dji.com/forum-139-1.html?from=developer

Okay! Thank you!

shahm Posted at 1-24 00:59
Okay! Thank you!

No probs shahm.   

Here are the key steps to communicate with the Robomaster Development Board Type A:

•     Connect the Robomaster Development Board to your computer.
•     Install the necessary drivers.
•     Choose a communication protocol.
•     Write code to communicate with the board.
•     Send and receive data.
  

https://www.tatvasoft.com/outsourcing/2022/04/what-is-software-testing.html