Hello,
I'll try my best to explain what I want being a french canadian .. ;)


At my work, I would like to map the inside of a furnace. (a 22' diameter cylinder and 70' height)
The wall of the furnace is covered with refractory bricks.

After each plant shutdown, I'd like to map the current state/wear of the bricks.

Is there a way to produce a 360 photo deployed.
I would like to take a 360 photo on every 8 feet altitude, I could then stitch those picture to get a complete deployed/flatten picture of my furnace.

I only see a 360 spherical mode, I don't like that mode because it makes a lot of deformation on the picture.


Thanks a lot,
JP

I think you'd have to use the 180 degree pano and take two shots at each level an and then increase the altitude and repeat.  

So far you can only achieve this manual I think .

Does Litchi has this possibility?

I wouldn't fly a drone in that if I were you.