Hello Everyone, I bought a used Phantom 2 Vision from B&H and I connot figure out what is going on with it. The LEDs on the unit quickly flash yellow and the led on the controll board flashes red at the same time. I have connected the phantom to the Assistant software and updated it. I also updated the RC firmware. I didn't notice any errors when I connected the phantom or the rc. Any Ideas?

Sorry, I cant help you.
But...please, please dont try to fly it until you understand what you need to understand.

Many here will help you..good luck.

Go here FIRST.
Read it, learn it, love it

http://www.dji.com/product/phantom-2-vision/download

Hi gseaver4,
According to what you said, you may need to follow these steps:
1. Download link: http://www.dji.com/product/phantom-2-vision/download
2. Charge the battery of your remote controller first (Please check the user manual, P.9)
3. Turn on the remote controller first and then turn on the aircraft
4. If the yellow light is flashing, please find out the pin hole on the bottom of the aircraft and use a pin to stab in to reset the link between remote controller and aircraft. (Please check the user manual, P.12)
Hope this may help and please read manual and videos from the website thoroughly. Enjoy your flight!