cbx1963
lvl.3
United Kingdom
Offline
|
The parts I bought work just fine my phantom now runs on 2.4Ghz .. it appears that the RX plugs are opposite to the 5.8ghz rx swapped em over loaded the Naz assistant and bingo TX calibrated
5.8Ghz Fpv stuff for Xmas please.
Just swapped the Rx and Tx out of my fc40 for a 2.4Ghz Rx/Tx dji part 31 and dj6 tx but cant calibrate the controller I get error
(CFG-ERR##Configuration error, this may be caused by firmware upgrade from the old version, or abnormal Tx calibration. Re-calibrate your transmitter, power cycle your controller, and check all of the parameters)
in fact its as if its not bound there is no response from Tx at all. works fine in RC assistant though.
any thoughts ?
|
|