Ronin SC2 firmware has been updated. Gimble is balanced and has been used.
Today after adding focus motor from RSC 2 pro combo and RSC2 re balanced and motors calibrated.
Motors vibrating and a message. Stating inconsistent Firmware. Press side dial to update.
Since the firmware was updated after first set up, using dji app, there is no message that there is a recent firmware update.

Hi, chalice.hares_0w. Thank you for reaching out and we're sorry for the inconvenience. Please follow the steps below:

1. Kindly remove the camera control cable before updating.
2. Please update the firmware again through Ronin App, the upgrade steps are as follows.
Click on the list in the upper left corner to enter the "About" page, click on the firmware version, press and hold the text of the firmware version for 5 seconds in "Firmware version", and then you can choose the version V01.04.00.20 to upgrade.
3. Reset the stabilizer parameters, replace the focuser motor control line, and update.

Please keep us posted. Thank you.