Hi.

I recently acquired an old original Ronin (1. Gen), mounting my FS700 and stabilized it. When powering the Ronin on, the motors start up, and things seem to be working. All the axis seem to work fine except the roll axis, but only in one direction. As soon as I start rotating the handles to my left all the motors dies. (see video)

I have tried to do factory reset, System calibration and Auto calibration.

Firmware:

Has anybody experienced the same issue or something similar?

Anybody have any ideas if there are some malfunctions to the Ronin’s hardware?

Hope someone has a solution for me

Hi.

I recently acquired an old original Ronin (1. Gen), mounting my FS700 and stabilized it. When powering the Ronin on, the motors start up, and things seem to be working. All the axis seem to work fine except the roll axis, but only in one direction. As soon as I start rotating the handles to my left all the motors dies. (see video)

I have tried to do factory reset, System calibration and Auto calibration.

Firmware:

Has anybody experienced the same issue or something similar?

Anybody have any ideas if there are some malfunctions to the Ronin’s hardware?

Hope someone has a solution for me