I need to livestream from the DJI LightBridge. I use Wirecast and the Black Magic Intensity Shuttle.
But when I plug in the HDMI from the LightBridge nothing happens.
Update. The problem is still not solved but i realized this:
When using the new Ground system decoder* v1.4.7 it seems the Wirecase is not recognizing the input from the Lightbridge.
In the source sittings in wirecast the video format is not right. It is 1080p25 regardless what I set the LightBridge to output.
When using the old Ground system decoder* v1.4.5 wirecast recognize the Lightbridge and gets the video format right. But the lightbridge does not send the videosignal through the HDMI port. I can tell because I can get the video signal from the USB.
When I plug the HDMI cable from the lightbridge to a HD monitor it works, but when I plug it in the Intensity Shuttle it will show a still picture and not more. The video signal to USB then takes over.
I have the same problem with an Elgato game capture HD 60 which can't pass through HDCP signal. I have order an Hdmi switch which probably kill HDCP encoding. When I test it I tell you if it works on my Mac. I need to use an Intensity shuttle too and if it works with HD60 I will try it with Intensity shuttle.I hope that it is not finally impossible to broadcasting with a LB...
Tahoe_Ed Posted at 2014-12-9 10:14
It is probably a compatibility issue with your device. I don't think that DJI has stated that Black ...
Hi, could you confirm that is possible to use Lightbridge with a Macbook Pro in Live View, with a Blackmagic Extreme Intensity box and a thunderbolt cable.
I have the same problem with an Elgato game capture HD 60 which can't pass through HDCP s ...
Mickael, I have gone from a Lightbridge slave unit direct to the Board using a HDMI to SDI converter. There are several that are compatible, not all are however. Make sure that your firmware is up to date. There have been changes on the compatibly side recently.
I made a little experiment with another LB with Ground decoder V1.4.6. And is works with the Intensity Shuttle right away,
But I need to "Downgrade" another LB. So where to get V.1.4.6?
I want convert the HDMI signal to an HD-SDI signal, but with the DHCP protection i have just a picture freeze.
I have tried with different converter like the blackmagic, the decimator and the Yellow brik.
Did you know a converter who can delete the DHCP protection?????