Hey you all,

I am using the DJI FPV Remote Controller 2 with a DJI o3 Air Unit.
I would like to configure certain Modes in Betaflight like PreArm using a momentary Switch, so that they are only activated when i hold down a Button.
I planned to use the 'Photo', 'Pause' and 'Start-Stop' Button to trigger these Modes, but all Buttons seem to not be momentary...
Is there any way to change the behaviour of these Buttons?

Kind regards

I had the same issue. The solution was very simple: TBS Tango 2 Pro! :-) On a serious note, no you can't make RC2 switches momentary. You also can NOT use/map "Photo/Rec" button of RC2 in Betaflight.

djiuser_LsAudeekKkCJ Posted at 4-7 06:08
I had the same issue. The solution was very simple: TBS Tango 2 Pro! :-) On a serious note, no you can't make RC2 switches momentary. You also can NOT use/map "Photo/Rec" button of RC2 in Betaflight.

Ahh, sh*t. Was really hopping for this to be possible but I searched the entire internet and did not come across a solution.
Thanks anyways for your Help.