Dear Forum Members,

    I am reaching out to this forum community to ask about the model CAD for the DJI RS2. Maybe anybody or the Designer Team has that file.
I will be very grateful for any information because it will make our team's work much easier.
Thank you in advance for your time and assistance.

Best regards,
Piotr

Edit.
We want solving problem which was describing here: https://sdk-forum.dji.net/hc/zh-cn/community/posts/14951136056345-DJI-RS2-control-over-CAN

" I'm trying to control DJI RS2 over CAN bus. I'm using Gimbal Position Control  (CmdSet = 0x0E and CmdID = 0x00) and everything works fine but when I'm trying to set roll angle, gimbal also moves in yaw axis. Is there a way to prevent this? I would like to set roll without moving yaw axis. I've tried to use other command sets from DJI R SDK Protocol and User Interface, but nothing helped. "

Dear Forum Members,

    I am reaching out to this forum community to ask about the model CAD for the DJI RS2. Maybe anybody or the Designer Team has that file.
I will be very grateful for any information because it will make our team's work much easier.
Thank you in advance for your time and assistance.

Best regards,
Piotr

Edit.
We want solving problem which was describing here: https://sdk-forum.dji.net/hc/zh-cn/community/posts/14951136056345-DJI-RS2-control-over-CAN

" I'm trying to control DJI RS2 over CAN bus. I'm using Gimbal Position Control  (CmdSet = 0x0E and CmdID = 0x00) and everything works fine but when I'm trying to set roll angle, gimbal also moves in yaw axis. Is there a way to prevent this? I would like to set roll without moving yaw axis. I've tried to use other command sets from DJI R SDK Protocol and User Interface, but nothing helped. "